Westminster Electrical Company handles electrical work for homeowners, commercial property owners, and rental property managers across Westminster and Orange County. From a dead outlet that needs tracing to a full panel replacement or a new EV charger circuit, we cover the full range of residential and commercial electrical jobs. We are available 7 days a week, from 7:30 AM to 10:30 PM, evenings included, so you are not stuck waiting until Monday to deal with something that needs attention now.
Flickering lights and warm outlets are warning signs, not quirks. When something in your home's wiring does not feel right, the right move is a call, not a wait. We are a local electrician for homeowners and commercial clients alike, and we scope every job on the phone before anything is scheduled. We power your home. We protect your circuits. We earn the call.
One call and we are on it.
Before a small wiring issue turns into a hazard, it usually announces itself. A breaker that trips every time the microwave runs. An outlet that stopped working with no obvious cause. A faint burning smell near a switch plate. Lights that flicker when nothing else is on. These are the jobs we take on, and each one starts with a proper diagnosis rather than a parts swap.
Troubleshooting electrical faults means following the circuit from the symptom back to the source. A dead outlet might trace back to a tripped GFCI device three rooms away. A sparking outlet might point to a loose connection that has been arcing quietly behind the cover plate for months. A buzzing panel is worth investigating before it becomes a bigger problem. We give you straight answers about your panel and wiring before we talk about what the repair involves.
GFCI and AFCI protection are part of this work too. Kitchens, bathrooms, garages, and outdoor circuits all require ground-fault protection under current code, and older Westminster homes often have outlets that were never updated to meet it. AFCI protection, which guards against arc faults in bedroom circuits and elsewhere, is increasingly required on new and updated work. Where protection is missing or outdated, we bring the circuit up to where it needs to be.
We'll make your wiring safe again.
Your home deserves wiring that's safe and up to code, and the panel at the center of it all is where that standard either holds or falls short. A panel that was sized for a smaller load does not grow with the house. When circuits trip regularly, when you cannot add an appliance without overloading a breaker, or when a buzzing sound comes from the panel itself, those are signs the existing service has hit its limit.
A 200-amp service upgrade replaces an undersized main panel with one that can carry the load a modern home actually draws. That means a new panel, updated breakers, and in many cases a service-entrance upgrade to match. Subpanel work follows similar logic: when a garage, an addition, or a workshop needs its own circuits, a subpanel feeds them from the main service without overloading what is already there.
Older homes in the Westminster area were commonly built with 100-amp service or less, which made sense at the time but does not account for EV chargers, electric ranges, heat pump water heaters, or a home office running full-time. A load calculation helps determine what the existing service can carry and what the upgraded service needs to handle. The price is confirmed before anything is scheduled, and you can ask what the scope covers when you call.
Give us a call and consider it handled.
Electrical work like this comes up more than people expect, especially in older housing stock. Westminster and the surrounding parts of Orange County include homes built in the 1950s, 1960s, and 1970s, many of which still carry original wiring. Knob-and-tube wiring, once standard, lacks the grounding and insulation that current code requires. Aluminum branch circuit wiring, common in homes built during a period when copper prices were high, needs specific connectors and devices to remain safe. Both are jobs we handle as part of broader rewiring and upgrade work.
Whole-home rewiring is one end of the spectrum. Dedicated circuit installation is the other, and it comes up constantly. A dryer, an electric range, a refrigerator, a hot tub, or a workshop bench grinder each needs its own circuit sized for the load it draws. Running a dedicated line for any of these means pulling wire from the panel to the point of use, installing the right outlet or connection point, and adding a properly rated breaker. Wiring for additions, garage conversions, and shed installations follows the same process.
All wiring work is checked against code before sign-off, so the job is done to the standard the area's inspectors enforce.
Outlets and switches are some of the most requested jobs we handle, and the range is wider than most people realize. Standard outlet replacements, GFCI upgrades for kitchens and bathrooms, AFCI outlets for bedroom circuits, USB outlets for charging stations, weatherproof outlets for outdoor use, and tamper-resistant outlets for homes with young children all fall under this category. Each has a specific application, and getting the right one in the right location matters.
Switch work covers the same range. A standard single-pole replacement, a three-way switch for a hallway or staircase, a dimmer for a dining room or living space, and a timer switch for an outdoor fixture are all straightforward jobs that make a real difference in how a space functions. If a switch plate feels warm to the touch or a switch crackles when you flip it, that is worth a call.
Lighting installation runs from recessed can lights in a kitchen remodel to under-cabinet lighting in a workspace to outdoor security lights on a garage wall. In Orange County, outdoor living spaces get used year-round, and exterior lighting for patios, walkways, driveways, and entryways is some of the most practical electrical work we do. Ceiling fan installation and replacement rounds this out, both for new fan wiring where none exists and for swapping out an older fixture.
Westminster sits in a part of Southern California where the electrical demands on a home are specific. High grid demand during peak summer months, a housing stock that spans several decades of construction, and a lifestyle that puts outdoor and garage circuits to daily use all shape what the most common electrical jobs look like here. The services below reflect that.
Southern California has one of the highest rates of electric vehicle adoption in the country, and Westminster is no exception. A Level 2 home EV charger runs on a 240-volt dedicated circuit, typically a 50-amp line, and charges a vehicle several times faster than a standard 120-volt outlet. The installation involves running a circuit from the panel to the garage or driveway location, installing the right outlet or hardwired connection point, and confirming the panel has the capacity to carry the added load. If the panel needs an upgrade first, we handle that as part of the same project. Call for a quote and we will walk through what the installation involves at your property.
Surge protection at the outlet level covers individual devices. A whole-home surge protector, installed at the panel, covers everything connected to the house at once. In an area where summer demand spikes and utility switching events are common, panel-level surge protection is a practical layer of defense for appliances, electronics, and the wiring itself. The installation is straightforward: a surge suppressor is wired into the main panel and rated for the service size. It does not replace outlet-level protection for sensitive equipment, but it handles the large surges that bypass everything downstream.
Hot tubs, spas, and pool equipment are common on Orange County properties, and the electrical work that supports them is specific to the application. A hot tub or spa requires a dedicated 240-volt circuit with a disconnect mounted within sight of the unit. Pool pump motors, lighting circuits, and bonding requirements add more scope. This is outdoor electrical work with strict code requirements around water proximity, and getting it right means the equipment runs safely and the installation passes inspection.
When the power goes out, or when something in the wiring is not behaving the way it should, the type of property matters less than getting the right diagnosis and a clear answer about what comes next. We work across property types: single-family homes, condos, rental units, small commercial spaces, and new construction.
Homeowners call for the full range of repair and upgrade work. Rental property owners and landlords call when a unit needs outlet work ahead of a new tenant, when a panel is flagged during an inspection, or when a circuit needs to be added for a washer and dryer. Property managers handling multiple units call for the same reasons, often on tighter timelines. Commercial clients need panel capacity for equipment loads, dedicated circuits for machinery or server rooms, and lighting that meets the demands of a working space.
Electrical safety inspections are a standalone service that fits all of these. An inspection covers the panel, the wiring, the outlets, and the visible portions of the electrical system, and it produces a clear picture of what is current and what needs attention. We treat your home and its wiring the way we would our own, which means the inspection is honest rather than padded.
We are open 7 days a week, from 7:30 AM to 10:30 PM. That includes weekends and evenings, which covers most of the windows when people are actually home and available to meet someone for a repair or installation.
For urgent electrical faults, we take short-notice work. If a circuit has gone down, an outlet is sparking, or a panel is making noise it should not be making, ask what the schedule allows when you call. We will tell you what is open.
Pricing works the same way every time. You get the rate on the phone, before anything is scheduled. Ask what it covers and you get a straight answer. There is no ambiguity about what the quote includes, and the price is confirmed before the job starts. For larger projects, such as a panel upgrade or a whole-home rewiring, the scope is worked out on the call so the quote reflects the actual job.
We work with homeowners, landlords, rental property managers, and commercial property owners across Westminster and Orange County. Each type of customer has different priorities: homeowners want a clear diagnosis and a straight answer on cost, landlords need units that are safe and compliant, and commercial clients need work done around their operating schedule. We handle all of it the same way: scope it on the call, confirm the price, and do the work right.
You reach someone who knows the trade and can talk through the job on the phone. They can scope what the work involves, explain what the visit covers, and confirm the price before anything is scheduled. The call is handled here, not routed elsewhere.
Yes. We cover Westminster as the primary service area and regularly work in Garden Grove, Huntington Beach, Fountain Valley, Santa Ana, Anaheim, Stanton, Seal Beach, and Midway City. If you are in Orange County and are not sure whether we cover your address, call and ask.
Ask what the job involves, what the price covers, and whether the scope might change once the electrician is on site. Ask about availability if timing matters. We answer all of those on the call, and the price is confirmed before anything is scheduled so there is no ambiguity going in.
If the work on site turns out to be more complex than the initial description, we explain what we found before continuing. The price is not changed without that conversation first. This comes up most often on older properties where what is behind the wall does not match what the original scope assumed.
Electrical work can involve opening walls, pulling wire through finished spaces, or working in tight areas like attics and crawl spaces. We take care to limit disruption to the surrounding area and clean up the work site before we leave. If a job requires cutting drywall, we will explain what that involves on the call.
The same symptom, like a tripping breaker or a dead outlet, can have different causes depending on the age of the wiring, the panel type, and how the circuit was originally installed. A fault in a 1960s Westminster home with older wiring is a different job than the same fault in a newer construction. The diagnosis drives the repair, not a preset answer.
From everyday repairs and outlet work to panel upgrades, EV charger circuits, and full rewiring projects, we cover the electrical work that Westminster homeowners and Orange County property owners need most.
Call (657) 655-6946 to get a quote, ask about availability, or talk through what a job involves.
Call in the morning. Talk it through. Know the options by the end of the call.
(657) 655-6946